Cadet 8F2000 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Radiateurs Cadet 8F2000. Cadet 8F2000 User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
240/208 VOLT MODELS
2F350 6F1500
2F500 8F2000
3F750 8F2500
4F1000 8F2025
5F1250 10F2500
208 VOLT MODELS
2F500-8 3F750-8 4F1000-8
5F1250-8 6F1500-8 8F2000-8
8F2500-8
120 VOLT MODELS
2F500-1 3F750-1 4F1000-1
6F1500-1
The
Cadet
Electric
Baseboard
OWNER’S
GUIDE
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING!
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.
CAUTION - High Temperature. Keep electrical cords, drapes, and
other furnishings away from heater.
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. The heater must be grounded to the grounding pigtail (copper
wire) provided.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil, grease,
hot surfaces or chemicals.
7. Do not place heater against paperboard or low-density
cellulose fiberboard surfaces.
8. Do not place heater below an electrical convenience receptacle.
9. WARNING
Overheating or fire may occur. Do not install the heater behind doors.
10. WARNING
Fire or explosion may occur. Heater has hot and arcing or sparking
parts inside. Do not install heater in any area where combustible
vapors, gases, liquids, or excessive lint or dust are present.
11. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns, do
not let bare skin touch hot surfaces. Use extreme caution when
any heater is used by or near children or invalids and whenever
the heater is left operating unattended. Keep combustible mate-
rials, such as furniture, pillows, bedding, papers, clothes, and
curtains away from heater.
12. WARNING
Risk of electrical shock. Do not insert or allow foreign objects
to enter any ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
13. WARNING
Risk of Fire. Do not block heater. To prevent a possible fire, do
not block air intakes or exhaust in any manner. Heater must be
kept clear of all obstructions: minimum of 12 inches in front and
above, 6 inches on both sides. Heaters must be kept clean of
excessive lint, dirt and debris. (See Maintenance Instructions)
14.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electrical
shock, or injury to persons.
Features & Benefits
Oversized high temperature limit switch with full
length sensor for added safety
Durable steel sheathed element with a limited
lifetime warranty
Easy installation with pre-punched case at 1” intervals
Rugged steel construction
Thermostat not included
Tel: 360-693-2505 Fax: 360-694-8668 P.O. Box 1675 Vancouver, WA 98668-1675
TOOLS REQUIRED
Phillips
Screwdriver
Straight
Screwdriver
Wire Strippers
Drill or Hammer
Drill Bits
(4) Wood Screws
Wire Connectors
(1) Strain Relief
Connector
Vue de la page 0
1 2 3 4 5 6 ... 11 12

Résumé du contenu

Page 1 - SAVE THESE INSTRUCTIONS

240/208 VOLT MODELS2F350 6F15002F500 8F20003F750 8F25004F1000 8F20255F1250 10F2500208 VOLT MODELS2F500-8 3F750-8 4F1000-85F1250-8 6F1500-8 8F2000-88F2

Page 2 - Installation Instructions

Figura 9Aparece elcableado dellado izquierdoFigura 8Aparece el cableadodel lado derechoZÓCALOS ESTÁNDAR: CABLEADO EN EL LADO DERECHO SUMINISTRO DE 12

Page 3

BACABLEADO DE MÚLTIPLES ZÓCALOS. SUMINISTRO DE 240V SOLAMENTE (Consulte la figura 14)1. Cableado del lado izquierdo: desempalme el conector de fábrica

Page 4 - Instructions

* El hollín y los residuos se forman por la combustión de los hidrocarburos. Los hidrocarburos existentes en el entorno pasan por el elemento calentad

Page 5

THERMOSTATA thermostat is required. A Cadet wall thermostat is recommendedfor optimum performance, or you may prefer the convenience of abuilt-in ther

Page 6 - Operation & Maintenance

NOTE: You do not need to disassemble any additional parts to mountthe heater.6. Connect the grounding lead to the grounding pigtail (copper wire)with

Page 7 - CONSERVE ESTAS INSTRUCCIÓNES

Figure 9Left Side Wiring ShownFigure 8Right Side Wiring ShownSTANDARD BASEBOARD WIRING ON RIGHT SIDE 120V OR 240V SUPPLY (See Figure 8)1. Connect one

Page 8 - Espaciado mínimo de 12”

BAMULTIPLE BASEBOARD WIRING. 240V SUPPLY ONLY (See Figure 14)1. Left side wiring: disconnect factory connector A. Rightside wiring: disconnect factory

Page 9 - PASO 2: Cableado del zócalo

* Black soot and residue is formed by the combustion of hydrocarbons. Existing hydrocarbons in environment pass through heater element and scorch, ex

Page 10 - Alambre rojo

MODELOS DE 240/208 VOLTIOS2F350 6F15002F500 8F20003F750 8F25004F1000 8F20255F1250 10F2500MODELOS DE 208 VOLTIOS2F500-8 3F750-8 4F1000-85F1250-8 6F1500

Page 11 - ESTÁNDAR

TERMOSTATOSe requiere un termostato. Se recomienda un termostato mural Cadetpara un óptimo rendimiento, o bien puede optar por la comodidad de unjuego

Page 12 - GARANTÍA

NOTA: No es necesario desarmar ninguna pieza adicional para montarel calentador.6. Empalme el conductor a tierra al cable en espiral (de cobre) de pue

Modèles reliés 2F350

Commentaires sur ces manuels

Pas de commentaire