Figure 9
Left Side
Wiring Shown
Figure 8
Right Side
Wiring Shown
STANDARD BASEBOARD WIRING ON RIGHT SIDE
120V OR 240V SUPPLY (See Figure 8)
1. Connect one supply wire to one heater wire.
2. Connect remaining supply wire to remaining heater wire.
3. Replace wiring compartment cover and secure with screw
previously removed.
4. Turn power back on at the electrical panel board.
STANDARD BASEBOARD WIRING ON LEFT SIDE
120V OR 240V SUPPLY (See Figure 9)
1. Connect one supply wire to one heater wire.
2. Connect remaining supply wire to remaining heater wire.
3. Replace wiring compartment cover and secure with screw
previously removed.
4. Turn power back on at the electrical panel board.
Installation
Instructions
MULTI-WATT BASEBOARDS: WIRING ON RIGHT SIDE
MODEL 8F2025 (See Figure 10)
1. Connect one supply wire to the upper black wire.
2. Before proceeding, you must decide whether you prefer
2000 or 2500 watts.
a. For 2500 watt applications: Connect the remaining supply
wire to both the black and red wires (3 wire connection).
b. For 2000 watt applications: Connect the remaining supply
wire to the remaining black wire. Leave the red wire
disconnected and cap loose end with an approved wire
connector, or wrap loose end with electrical tape.
3. Replace wiring compartment cover and secure with screw
previously removed.
4. Turn power back on at the electrical panel board.
Figure 10
Right Side
Wiring Shown
Model 8F2025 -
Factory set for
2500 watts
Model 8F2025 -
Factory set for
2500 watts
Refer to the wiring diagram below that corresponds to your heater application.
For single wattage baseboards, refer to “Standard Baseboards.”
For multi-watt baseboards, refer to “Multi-Watt Baseboards.”
MULTI-WATT BASEBOARDS: WIRING ON LEFT SIDE
MODEL 8F2025 (See Figure 11)
1. Connect one supply wire to one heater wire.
2. Connect remaining supply wire to remaining heater wire.
3. Replace wiring compartment cover and secure with screw
previously removed.
4. Selecting desired wattage
a. For 2500 watt applications: No action is required.
Heater is factory set for 2500 watts.
b. For 2000 watt applications: Remove right wiring compartment
cover. Cut red wire and cap both loose ends with approved
wire connectors, or wrap both loose ends with electrical
tape. Replace wiring compartment cover and secure with
screw previously removed.
5. Turn power back on at the electrical panel board.
Figure 11
Left Side
Wiring Shown
Baseboard Heater
To Supply
Side ʻBʼ Shown
Supply Wires
Ground
Side ʻBʼ Shown
Supply Wires
Ground
Upper
Black
Wire
Red
Wire
STEP 2: Baseboard Wiring (continued)
Baseboard Heater
To Supply
Side ʻAʼ Shown
Supply Wires
Ground
Baseboard Heater
To Supply
Side ʻAʼ Shown
Supply Wires
Ground
Baseboard Heater
To Supply
Red
Wire
2000 Watt Configuration
Red
Wire
2000 Watt Configuration
Right Side
of Baseboard Shown
(8 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels